STANDARD ADAPTER | CNC ADAPTER

General Notes on Adapters for BERGER Multi Spindle Drill Heads
The mount and drive of a BERGER multi spindle drill head depend on if it can be attached to a stationary, non-rotating part of the machine concerned (standard adapter) or if it is necessary to attach the multi spindle drill head to a rotating part of the machine (CNC adapter).

Standard Adapter
The below illustration shows a BERGER multispindle drill head with an adapter for mounting on a non-rotating machine part (e.g. quill, spindle housing, angle iron, etc.). A flange transmits the axial forces from the multi spindle drill head to the machine. The flange is either screwed or clipped to the machine. The driven part supports only the torque required for working.

Questionnaire for Standard Adapter (PDF)

CNC Adapter
The illustration shows a typical adapter for a BERGER multi spindle drill head on a CNC machine. All forces - the axial forces as well as the required torque - are supported by a machine-driven part (usually ISO, CAT, BT or HSK Taper) and an anti-rotation pin.

Questionnaire for CNC-Adapter (PDF)